There’s also the Power on Reset (PoR):
- Make sure the AP is not plugged into Ethernet
- Locate the reset button on the back/bottom of the unit
- Press and hold the reset button
- While still holding the reset button, plug in Ethernet with PoE in to the AP
- Continue holding the reset button for approximately 5 seconds OR until you see a change in the LED on the AP
Our power on reset (a.k.a. POR) is a bit different from other vendors’. By holding the reset button, you’re not only factory defaulting the AP, but during that process, the AP will attempt to reach out to the internet, download and apply a preset version of the AP’s firmware. If you do see a change in the LED of the AP after doing this, you’ll want to let the AP sit for a couple of minutes given all the processes it is going through. The end result should be a solid white LED for at least a minute.