Provisioning in Office prior to Delivery

[Beaker]

For device firmware updates, follow the instructions below.

Unit Bricked - not working

There’s also the Power on Reset (PoR): Make sure the AP is not plugged into Ethernet Locate the reset button on the back/bottom of the unit Press and hold the reset button While still holding the reset button, plug in Ethernet with PoE in to the AP Continue holding the reset button for approximately 5 seconds OR until you see a change in the LED on the AP Our power on reset (a.k.a. POR) is a bit different from other vendors’. By holding the reset button, you’re not only factory defaulting the…

Pre-Provisioning for now:

Pre Programming?

There is some support for this. You can configure anything about a site from the dashboard, except individual device parameters that would be tied to the MAC address of the hardware you’re adopting. For example, you can prepare the entire wireless network design without any access points on hand, but you cannot adjust the individual AP settings until it is adopted. You could potentially adopt the devices on a lab network to prepare them, then use the Move feature to transfer them. I am not exac…

Or what Josh has stated above.