Hello
who has already discovered this and when will it show more?
greetings thomas
Hello
I tried firefox and chrome, unfortunately nothing is displayed
Now I tested it on my iPhone with Safari, unfortunately nothing is displayed
The new topology map primarily relies on LLDP to build the topology. If no devices in your network support LLDP, then it makes sense that it would be sparse or blank, in your case.
Are there any devices on your network that support LLDP? How much of your network is Alta gear?
Hello
I have 7 AP 6-Pro and 1 Alta Lab 24 port switch
and various devices. iPhones, tablets, smart TVs, cell phones etc…
How is your Alta Control set up? Is it the appliance, the Docker image, or the LXC image?
Hello
Everything in the cloud, no docker or anything else…
Ah, apologies, it’s posted on Alta Control. We’ll have to get some more categories rolling soon.
A developer pinged me about your post. There are some corner cases where the map doesn’t properly generate, I’m told this will be fixed next week.
It was called topology then they renamed it already
Mine is also
Showing blank with similar setup, 2 AP 6 pros and the 24 port switch
I’m not seeing this in the hardware controller.
Was there a solution for this? My Map also does not render.
I only have the 8 port switch, does this require more than one Alta device to populate?
When i enabled lldp on pfsense it started to populate the whole map.
That’s right. Make sure you have LLDP enabled across your network to populate the map.
Ah ok. Installed and enabled LLDP and SNMP on the machine hosting my controller container. All works now!
My VZW router/gateway is on port 8, all Wireless IP’s its given out are showing on port 8… is that normal? Should I create a new post?
Sounds about right if its a wireless router.
Ok cool. Thank you!