How to disable default NAT translation? Please explain and support me

[tazar.phyowai]

Dear ALL,

In our network design, we are using static IP addresses on the WAN interfaces and have configured the required default gateway as well. However, we would like to disable NAT from running by default.

On the Alta Route10 device, NAT appears to be enabled automatically, and we do not want NAT to run in our setup. Could you please advise how we can completely disable the default NAT behavior on the Route10?

Thank you.

Best Regards,
TAYZAR PHYOWAI

[Alta-Jeff]

We are looking into this. There have been enough requests that we will likely add this option in the next couple of weeks.

[jmszuch]

Otherwise I know @Alta-MikeD wrote this up as a potential way to disable NAT from the command line until such a feature might be implemented in the controller:

Add “Disable NAT” Option for LAN-to-WAN Rule in GUI Cloud Portal

Thanks for the feature request submission! To clarify, the commands that were shared were solely an example of how it can be done. Technically what you want to do can be done immediately, but it requires more custom work. As you notice, right now it applies to the WAN which affects all in that zone. It’s unfortunately not maintainable to support all custom configurations fully, which is why we share partial examples. I do understand that your preference here as well. What you need to do is bre…

[tazar.phyowai]

@Alta-Jeff

We are looking into this. There have been enough requests that we will likely add this option in the next couple of weeks.

Thanks

[tazar.phyowai]

Thank u so much. I will try it.