Control display bug for LAG connections?

[rutman286]

I have a Synology NAS connected with static LAG to my S24-POE switch. The LAG is working perfectly well, but control does not seem to know how to show the connection. Here is what the Synology looks like. It shows up on the WAN port of Route10.

[ebuckland81]

@rutman286, I found this thread of your’s right now. I guess we, once again, stumbled upon the same (or related) bug. See my thread here:

@ebuckland81

However, my experience of reporting on LACP ports/devices is that what is shown in the devices list is a bit uncertain, it shows wrong Link, Ch/Port and VLAN or sometimes some of them correct or partially correct.

Hopefully your issue has also been resolved by the latest firmware, Switch version 2.1s:

@Alta-MikeD

S8/S16: Resolve incorrectly reported ports on LACP links.

[rutman286]

LACP connections are still shown twice with no IP on the dashboard.

[ebuckland81]

Ch/Port and Link seems ok now!? But too bad about the IP. I got the IP shown at least, but unfortunately no traffic shown in the Devices list:

@ebuckland81

However, it seems like there is no traffic stats shown for the LACP port/device in the Devices view.

About the two devices/connections:

@Alta-MikeD

Sometime down the road we will merge LAGs in a logical way to clean up the client device list.

[Alta-Jeff]

To view traffic for LACP links, please refer to the Switch device’s traffic stats.

[ebuckland81]

@Alta-Jeff

To view traffic for LACP links, please refer to the Switch device’s traffic stats.

Yes, noted.

@ebuckland81

Meanwhile, there seems to be proper reporting in the Switch S8 traffic view.

We’ll use the Switch device’s traffic for the LACP links while awaiting a fix for the devices view.