Periodically my 3 APs change IPs. I made sure to setup static configurations outside the DHCP range (.7, .8, .9) and somehow the IPs change. Most recently they get set to a static IP on the DHCP range. Anyone else experience this?

As Joe and Mike noted. You can toggle the “Fallback upon failure” option to prevent this from happening again. It sounds like it was caused by losing connectivity, most likely when patches were applied. You can then reboot the device. Go to settings, scroll to where you see “Save” hold the shift k…

AP IPs Changing - Static Configuration

Access Points

DN3092 April 1, 2025, 7:10pm 10

I’m having the same issue here, fallback is off yet it does it anyway.